Video introduction to Climatherm Revit MEP content created by Productspec is now available to download.

In conjunction with Productspec we are now pleased to present Revit MEP content for the aquatherm Climatherm HVAC system.

Using this content enables Revit users to quickly and easily specify the Climatherm system within Revit MEP (Mechanical, Electrical & Plumbing).  It has been robustly created to enable intelligent, full-system, parametric design.

Each individual part of this manufacturer-approved system can be interconnected and utilised to create itemised schedules on the fly.  If you're a Revit user you can expedite your design and specification process and access the aquatherm fusiotherm Revit content here (14.4Mb)

Specifying climatherm pipes

Climatherm SDR-11 composite pipes need to be specified in combination with brand matched fusiotherm fittings.

It is essential that climatherm pipes and fittings are installed in accordance with aquatherm technical installation and pressure requirements. All climatherm installations are to be installed by registered aquatherm installers.

Please do not hesitate to contact us for any further assistance you may require in the selection of pipes and components for your projects and any queries that you may have on the suitability of our product for your specific installations.

Climatherm pipes and fittings are specifically for mechanical installations as listed below.

• Chilled water installations from -20°C to 12°C
• Heating installations to 90°C
• Radiator connections
• Compressed air
• CO² gas
• Non-potable grey water
• Chemical lines and aggressive fluids

Note: climatherm pipes are not suitable for potable water installations.